command line interface with verbose mode

[Payne Cheng]

hi....

i use the cli with verbose mode to monitor the progress of nessus scan process.

There're  two problems...

1. Although i can see the status message ( eg. attack | 1.1.1.1 | 55 | 80 ), there is no finish
    message when the scan ends. ( eg. finished | 1.1.1.1 | |  )

    In nessus.c, finish message should be printed out, but it doesn't. why?

2. Take ( attack | 1.1.1.1 | 0 | 50 ) as an example,  the scan usually stops 'correctly'  without finishing
    the 50 tests. For example, the scan finished  after ( attack | 1.1.1.1 | 35 | 50 ). 
    i have already enabled 'auto enable dependency'.
    Is there anyone who notice this fact ?

best regards
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mail.nessus.org/pipermail/nessus/attachments/20030926/08d57ad7/attachment.html